Simulator
Runs the actual V0061.37 firmware on a faithful 1802 emulator — the same bytes the hardware executes. Step one opcode at a time and watch a VM core change, a lamp for every bit, or switch to the digital view; the side panel follows the running program.
While paused, click a lamp with a ring to flip that bit: the registers, accumulators and four of the flags. A busy bit glows at the share of the time it is on. Rows the last step changed are marked, and the numbers count the raw 1802 instructions behind each opcode. Click a program line to set a breakpoint.
Serial terminal
Click the terminal and type to send keys to the running program — Enter, Backspace and Ctrl-key combinations all go through. On a phone or tablet, tap the terminal for the keyboard; the arrow keys, Esc and Enter are in the row underneath. The input box above just pre-loads keystrokes before you start.
Front panel
Q through a speaker: the program's own pitch, at the Elf2K clock only.
INPUT is EF4. 🎤 Listen keys it from a tone the microphone hears - another computer running Morse Sender v18, say.
Memory — $2F00 to $7EFF
CIDP page, the four VM cores and the four program blocks. Updates live as the program runs. Click a line in the disassembly to set a breakpoint.
Run it on a real Elf2K
Everything this simulator runs is available for the hardware. Load the firmware once, then any app.
STELLAR V0061.37 as Intel HEX, built from exactly the image this page runs. Send it to the monitor as a text upload.
Every finished app as a .lst: load its D-lines into the monitor, then run STELLAR.
The first step runs STELLAR's CD label pre-pass; interactive stepping then begins at the first real instruction. Look up any opcode in the reference.